Based on a current sensor module and based on the principle of the hall current which convert current into an analog voltage output; MCU (Arduino UNO R3) that includes AD converter can be read out and converted into measured current value; Suitable for SCM system powered by 5V power supply; Can measure AC and DC; Widely used in over-current detection current monitoring and other occasions.
Introduction The power supply is isolated industrial power supply built-in modules with temperature protection overcurrent and short circuit full protection AC 85~265V wide voltage input high voltage isolation 431 precisely regulated DC 24V output. Working temperature: -20 ~ 60 ° Relative humidity: 40 ~ 90% RH Input voltage range: 85 ~ 265VAC Input Current: 0.0273A (AC110V) 0.014 (AC220V) A Input inrush current: 20A Output Voltage: +24 V Maximum current: 200mA Peak current: 250mA Output voltage range: 23.80 ~ 24.2V Ripple: 150mV Output overvoltage: 23.8 ~ 24.3 Output Over Power Protection: Short circuit protection: Temperature protection: Overcurrent protection: Yes Installation 1. It can be installed at the input and output pins soldered directly on the PCB; 2. A plastic fixed.
Use advanced synchronous rectifier controller and 3.7m ohms low impedance NMOS swith tube to high current and high efficiency DC-DC buck converter; Input voltage: 16~40V (rated 24V); Output voltage: 1.0~12V; Output current: 6A (Natural heat dissipation); Load starting current: rated 6A Max. 7A; Undervoltage overcurrent short circuit protection